Outdoor Furnace: How To Clean Your Filter In 15 Seconds New Procedure Announcement!

How To Clean Your Filter In 15 Seconds New Procedure Announcement!

Why Boilers Need A Filter

Sediment is the "Secret Killer" of outdoor boilers. It will eat through steel, AND cause electrolysis damage to your water jacket - holes in your boiler are very bad.

Most outdoor wood burner owners already have a filter. But some dealers make the mistake of NOT recommending a filter to "get the sale". This is not wise. If you don't have a filter, this is not your fault of course if your dealer did not even tell you about it. But you still need one to protect your system. Learn more by clicking HERE.

We get calls from outdoor boiler owners whose systems are from 3 to 7 years old and who need to replace all their heat exchangers at great cost. This could have been prevented if they had a filter.

Sediment Buildup

If you don't have a filter, you can install one now easily. This will reverse the damage being caused by sediment, and clean up your system perfectly!

Filter kits are available! They include literally every component needed to install a filter, including the bypass. A bypass is required to allow the water to continue flowing while the filter is getting cleaned every month or two. Simple instructions and drawing for the filter are included with every Filter Kit. Click HERE for more info on Filter Kits.

 

Outdoor Boiler Filter Kit

 

A filter will enable you to Turn UP Your Thermostat and Still SAVE Money on your heating bills for decades with your outdoor wood boiler!

You can now clean your filter in 15 seconds!  While you should still remove the filter cartridge and give it a good cleaning as needed, you can now flush sediment from your filter cartridge quickly and easily using this new method.

 Under normal operation, your bypass is closed, and water flows through the filter as shown in Figure 1 below.  Note that water normally flows from the outside INWARD through the filter, so any sediment trapped by the filter will collect on the OUTSIDE of the stainless steel filter cartridge.

 
Filter Kit Assembly

New Procedure Explained

Utilizing the new "QUICK-FLUSH" cleaning procedure, you simply do the following:

  1. Open the bypass valve
  2. Close Valve #1
  3. Hold a bucket under the filter (to catch water and sediment flushed out)
  4. Open the red valve at the bottom of the filter (see Figure 2 below)
 
Filter Kit Assembly

Figure 2

This procedure reverses the flow of water in the filter and forces water to flow from the inside out. Therefore, much of the sediment on the filter will flush out and flow into your bucket!

Maintaining a clean filter will extend the life of your boiler, and your heat exchangers!

Shop now!

Free Support and Fast Answers

With FREE Technical Support, our hundreds of videos, articles, operations & maintenance tips, and FREE Design Services, we guarantee that we will provide you the right answer to your question or solution to your problem."

 Our Customer Promise

Customer support begins with a great customer service team. Our dedicated team is trained and experienced in all things outdoor wood furnaces.

You can always expect a human on the other end of the line. We know what’s important to you - your family, saving money, and keeping your house toasty warm - and we make that our highest priority. Contact us!

 Free Water Testing

One of the most important steps in prolonging the life of your outdoor boiler is to ensure that the water in your boiler is not corroding the steel. Water starts to eat holes in steel immediately upon contact (through rust corrosion) unless properly treated. We test your outdoor boiler water for free! Get your wood boiler water treatment now!

Send your water samples!

Learn more.