"Should I Keep My Pump ON All Summer?" And What Can Be Done To Extend The Life Of My Pump?

"Should I Keep My Pump ON All Summer?" And What Can Be Done To Extend The Life Of My Pump?

Summer Shutdown time is done!  But, you may have asked yourself these questions:
 
- Should I keep my outdoor wood boiler pump on all Summer? 
 - What are the advantages of allowing the circulator pump to run all Summer?
 - What can I do to extend the life of my pump?
 - What is the silver button on the front face of the pump and how does this help me?

Here are the answers to these important questions:

First, the answer is YES, you should keep your pump on all summer. Here's two reasons why:

1 - Pumps last longer time if they are run continuously.

2 - If you heat your domestic water with your outdoor furnace, your hot water heater will use less fuel if you keep the pump onWhy? Let's say the water in your outdoor boiler is 80 degrees because your boiler sits in the hot sun all summer long. That 80 degree water is being circulated into your house and your plate heat exchanger.
When you use hot water for a shower or to wash dishes, cold water is added to your hot water tank. Most well water and city water comes out of the ground at around 52 degrees, even in the summer. 
Your hot water tank must heat that water from 52 degrees to 110 degrees using lots of fuel(electricity or propane or whatever). If your pump is on, the warm water in your outdoor wood furnace will heat that 52 degree water to about 80 degrees FOR FREE, thus cutting your fuel cost in HALF for your hot water heater during the summer!  

Please make sure your outdoor wood stove has PROPER WATER TREATMENT for the summer months. Whether the pump is on or not, you are the only one who can be responsible to protect your investment in your outdoor wood burner. (Read more reasons  why you should use water treatment HERE (including "It is like driving a car without oil!")

What is that silver button on the front of the pump face? You will see on the front of the pump (in the photo above), in the CENTER, there is a round silver button that can be removed with a flat-head screwdriver. If the pump is not functioning, you can remove that button to see if the shaft of the pump is spinning.

If you are not sure, or if it is stuck, turn off the power to the pump. Then, you can insert an Allen wrench into the pump shaft and turn it a few times. If it is caught on something, or has some sediment buildup, the pump will not circulate - but by doing this simple repair, you can usually save the pump! 

As always, let us know if there is anything we can do for you! Just contact us and call our office at (231) 861-8200 M-F 9am - 8pm, even during the summer!